2. Helpful Tips
3. Divided Cutting [DIVISIONcut]
4. Y Direction (Width Direction) Divided Cutting
5. Setting Y Direction (Width Direction) Divided Cutting

1. Y Direction (Width Direction) Divided Cutting

Setting Y Direction (Width Direction) Divided Cutting

1. Press the [FUNCTION] key in local mode.

2. Use to select [SET UP], then press the [ENTER/HOLD] key.

3. Use to select [DIVISIONcut], then press the [ENTER/HOLD] key.

4. Use to select [Y], then press the [ENTER/HOLD] key.

5. Use to select the [FRAME CUT] setting, then press the [ENTER/HOLD] key.

• Select [ON] if frame cutting is required.

6. Use to select the [MARK CUT] setting, then press the [ENTER/HOLD] key.

• Select [ON] if overlap margin marks are required.

7. Press the [END] key several times to exit.

• The settings are retained even when the power is turned off.
• The overlap margin measures 1 cm, so a width of at least 1 cm is required for the available cutting area.
• The data from the host computer can be ignored during divided cutting.
• Divided cutting is not possible in any of the following cases:
  - If the volume of cutting data exceeds the size of the receive buffer
  - If the cutting data contains an origin update command
  - If two-point line correction is set
  - If register mark detection is used
  - If the available cutting area is 1 cm or less
  - If test data has been cut within the machine
• Deselect the check box when divided cutting is used. (When FineCut/Coat9 is used, the default setting for the origin update command is "OFF". Refer to "5 Setting Head Position after Plotting" in the FineCut/Coat9 Reference Guide.)