1. X Direction (Feed Direction) Divided Cutting

Setting X Direction (Feed Direction) Divided Cutting

The data size in the feed direction will be cut divided at the positions corresponding to [Division Length + Cross Cut Length].
Setting the cross cut length cuts at the [Cut Length] position overlapping by the amount of the setting.

X Direction divided cutting figure
  1. Press the [FUNCTION] key in local mode.
  1. Use updown jog_ to select [SET UP], then press the [ENTER/HOLD] key.
  1. Use updown jog_ to select [DIVISIONcut], then press the [ENTER/HOLD] key.
  1. Use updown jog_ to select [X], then press the [ENTER/HOLD] key.
  1. Use updown jog_ to select [DIV.LENG], then press the [ENTER/HOLD] key.
  • Setting: 50 to 500 cm (in 50 cm increments)
  1. Use updown jog_ to select the [CROSS CUT] setting, then press the [ENTER/HOLD] key.
  • Setting: 0 to 50mm (in 1mm increments)
  • The sheet is cut with overlaps corresponding to the amount of the setting.
  1. Press the [END] key several times to exit.
  • The settings are retained even when the power is turned off.
  • The data from the host computer can be ignored during divided cutting.
  • Divided cutting is not possible in the following cases:
    - If the volume of cutting data exceeds the size of the receive buffer
    - If the cutting data contains an origin update command
    - If two-point line correction is set
    - If register mark detection is used
    - If the available cutting area is 1 cm or less
    - If test data has been cut within the machine