2. Before Using This Machine
3. Connect host computer to machine.
4. Using an RS-232C Cable
5. Setting the Computer Connection Conditions

1. Using an RS-232C Cable

Setting the Computer Connection Conditions

Set the communication conditions for the RS-232C interface.
The communication condition settings differ according to the command (AUTO, MGL-Ⅰc1, MGL-Ⅱc) set using command switching.

• If the step size has been altered, be sure to raise the pinch rollers using the clamp lever and reload the sheet.

1. Press the [FUNCTION] in local mode, press to select [SET UP], then press the [ENTER/HOLD] key.

2. Press to select [INTERFACE], then press the [ENTER/HOLD] key.

3. Pressto select [BAUD RATE] setting value, then press the [ENTER/HOLD] key.

• Settings: 1200, 2400, 4800, 9600, 19200, 38400 (bps)

• The recommended setting is 38400.
• Set the host computer transfer speed to suit the CG-AR.

4. Pressto select the following communication conditions in turn, then press the [ENTER/HOLD] key.

• Pressto select the setting, then press the [ENTER/HOLD] key to display the following items. Repeat the steps in turn until all settings have been set.

• Communication conditions: Data bits, parity, stop bit, handshake, step size, close time

5. Press to select the setting, then press the [ENTER/HOLD] key.

• Fore more information on the individual settings, refer to Notes on the setting items.

6. Press the [END] key several times to exit.