1. Cut the data.

Setting the Origin

Set the cutting start point. The origin set here will be the origin of the cutting software you are using.

When cutting the same data again, change the origin. If not, cutting starts at the same position.

Origin setting figure
  1. Press up jog_down jog_left jog_right jog_ in local mode to move the origin to the desired position.
  • Pressing the [TOOL] key raises and lowers the tool. Move to the correct position while checking the position where the tool was lowered.
  1. Press the [ENTER/HOLD] key.
  • The origin is set.
  • The available cutting area is displayed, and the tool conditions are then displayed.
  • Note that if the sheet sensor is disabled or if the carriage is above the sheet sensor and the front edge of the sheet has not been detected, the sheet may fall.