2. Options
3. Sheet Tables and Cutting Sheet
4. Cutting

1. Sheet Tables and Cutting Sheet

Cutting

Always use three pinch rollers. The middle pinch roller helps to prevent the sheet lifting up.

Setting the Number of Pinch Rollers to UseCenter ClampEnabling and Disabling the center clamp

1. Move the three pinch rollers respectively to the positions of the grit rollers shown in the figure below.

2. Push back the clamp lever to raise the pinch rollers.

3. Place the cutting sheet on top of the sheet tables, and pass it through to the platen.

• Insert into the gap between the pinch rollers and the grid rollers.

• Note the insertion direction of the cutting sheet.

4. Move the cutting sheet so that the left pinch roller is positioned as shown in the following figure.
   Move the right pinch roller to match the cutting sheet.

• Cutting and creasing will not be possible correctly in the following cases:
  

5. Align the front of the cutting sheet with the straight line at the front of the machine as shown in the figure below.

6. The middle pinch roller should be used, selecting High mode/Low mode or enabling/disabling the center clamp to suit the sheet being used.

• Setting the Clamp High/Low ModeCenter ClampEnabling and Disabling the center clamp

• The center clamp should be enabled (center clamp up) if you do not wish leave pinch roller marks on the sheet.

7. Pull the clamp lever toward you to lower the pinch rollers and clamp the cutting sheet.

• Check the following points before clamping the cutting sheet:
  ･ Check that the cutting sheet is not at an angle.
  ･ Check that the pinch rollers are correctly positioned.

8. For information on the cutting procedure, refer to the cutting process.

• Cutting Process, Process for Cutting Data with Register Marks

• Using [Read sheet] in FineCut/Coat9 reads in the size of the cutting sheet. Be sure to set the origin on the sheet on the machine before using [Read sheet] in FineCut/Coat9. Next, check to confirm that the cutting data fits within the sheet size before starting plotting.

9. Peel the sheet off the cutting sheet.

• Peel the sheet off slowly and carefully.
• When peeling off thin sheets, take care not to tear the sheet or leave parts attached to the adhesive surface.

Guideline Cutting and Creasing Condition List for Coated Card

The conditions listed here are only guidelines and do not guarantee quality.

Cutting quality may be reduced and the blade may become worn more quickly if conditions outside these ranges are used.

Method for changing the up height and sheet settings: SET UP