I want to perform registration mark cutting (contour cutting), but after sheet width detection, "TP1" or "SEARCH START POS" is not displayed.

  • Is "MARK DETECT" not set to off? Please set the detection points.

In the "SET UP" menu under "MARK DETECT", you can set the number of detection points for the registration marks read by the plotter itself.
The higher the number of detection points, the greater the cutting precision will be.

Please refer to the “Operation Manual” for the setting of [MARK DETECT].

* The display for waiting for registration mark detection varies depending on the model.
("TP1" or "SEARCH START POS" will be displayed.)

Return to Content