• Please see the following.

1. Check to see if the dongle is inserted firmly.

　* If your dongle does not come with the product, go to the step#2.

　　If your dongle did come with your RasterLink, please insert the dongle in your PC.
　　After rebooting RasterLink, re-perform RIP (RIP&PRINT or PRINT after RIP).
　　If the data gives the error message, [NOT REGISTERED] on the preview window,
　　then delete the job and get it to re-read a new job.


2. When using the previous version of RasterLink, please update it to the following
　 version.

　　RasterLinkPro5: Ver.4.10 or higher versions.
　　RasterLink6: Ver.1.60 or higher versions.

　　See the following manual for the update.
　　RasterLinkPro5: [Installation Guide]-[Updating the version of RasterLinkPro5]
　　RasterLink6: [Installation Guide]-[Updating the version of RasterLink6]

　　After rebooting RasterLink, re-perform RIP (RIP&PRINT or PRINT after RIP).
　　If the data gives the error message, [NOT REGISTERED] on the preview window,
　　then delete the job and get it to re-read a new job.


3. If the error message insists even after performing the procedure #2 above,
　 you need to reinstall RasterLink.

　　See the following FAQ for the reference.
　　RasterLinkPro5: Is it possible to reinstall RasterLinkPro5 by myself?
　　RasterLink6: Is it possible to reinstall RasterLink6 by myself?

---