- See the following.
1. Print the media feed correction pattern.
(The pattern will be printed to the full width of the set media.)
* When using roll media, ensure that there is no sagging of the roll media at the back of printer.
![](https://d15ouhvlj83qi.cloudfront.net/archives/046/202308/20c709955d91a75dc54049d805eaaabc66d50b1d7d3141b2bc26d0c0a1f18be0.png)
2. Check the correction value from the printed pattern.
* In the following cases, the correct values have already been set, so there is no need to
make any changes. Proceed to step 4.
![](https://d15ouhvlj83qi.cloudfront.net/archives/046/202308/f5aeba4f2c9d3484396d1988d7f9846109294dede015f58f2e93aa049d955690.png)
3. Change the correction values.
* In the following cases, it is necessary to change the correction values.
[NG]
- If there is a white stripe (gap) at the boundary between the first and second bands,
lower the correction value.
![](https://d15ouhvlj83qi.cloudfront.net/archives/046/202308/4d8c31fc84242858b06beea21feac59bbc78968bd6d0d3b30bcc3b67a8077982.png)
- If there is a black stripe (overlap) at the boundary between the first and second bands, increase the correction value.
![](https://d15ouhvlj83qi.cloudfront.net/archives/046/202308/830a73a13f433d99c24ed7f0f60a5f898b5f803fcbd1c43fe98c56dfea9d564c.png)
![](https://d15ouhvlj83qi.cloudfront.net/archives/046/202308/5fe9e3ecab49cf5b05adc642bf90b2986d1041018990a1f7a5cabb8d18e02716.png)
- When you decrease the correction value, the gap between the two bands will move closer.
- When you increase the correction value, the gap between the two bands will widen.
* When you change the correction value by "30", the width of the boundary changes by about 0.1 mm.
4. Once the correction is completed, prese [ENTER] several times to return to the [LOCAL] screen.
![](https://d15ouhvlj83qi.cloudfront.net/archives/046/202308/245eebd533c3fdf82958c929372e558bb584e4514b34c758b780bcd5673c5131.png)
[Notes]
If the printed pattern is as follows, there may be a possibility that the media is skewing (being fed diagonally).
Remove the media once and then re-set it again.
- There is a difference in the gap on the left and right sides.
![](https://d15ouhvlj83qi.cloudfront.net/archives/046/202308/df56e74aa77c279cbb26b8344f994747def19550ec748756c23a1be2ffd91a03.png)
* You can also change the correction values during printing using the following steps.
![](https://d15ouhvlj83qi.cloudfront.net/archives/046/202308/b264905474f2a9bc0786c224a7dc8e3cf2e47c9247268cf29c7707ee529a84a4.png)