MIMAKI INDIA PRIVATE LIMITED

Start and end points of cutting do not meet

  • If the start and end points of cutting do not meet, check on the followings.

1. Media itself is out of alignment
If the media itself goes out of alignment, see below
[Q. Media goes out of alignment ]

2. Media expands and contracts due to temperature and humidity
The media may expand or contract due to temperature and humidity.
Use the machine in a constant environment that meets the specifications.
[Q. Where do I need to place my machine? ]
In addition, always perform the pre-feed.

3. Cutting condition is appropriate
Make sure the pressure (PRESS), speed (SPEED), and offset (OFFSET) are appropriate.

4. Enable the dummy cutting
The dummy cutting (cutter blade aligning) operation improves the quality at the beginning of cutting.


Return to Content

PAGETOP