The existing cutting plotter could not cut rubber with thickness and hardness precisely. The area of the processing table was also small, and they wanted to increase the production efficiency. Since large products need to be made in sections and the labor of bonding occurs after cutting, they wanted to reduce the cost by processing them as a single piece.

Because CFX has a high cutting pressure and a large processing table, high-quality rubber products can now be mass-produced. Large materials can be cut only once, reducing the number of bonding steps. The processing speed is also fast so that they can handle urgent cases with plenty of time. Now that the company has more work to do, it can develop new businesses.

The amount of orders for deformed floor seats and life-size panel production is increasing year by year and overtime is a matter of course in the busy season. They wanted to automate the process of cutting large base materials, because there were some cases where the site was overcapacity at times and they had to turn down jobs that our sales staff had won.

Reduced the dependency on individuals of the work and labor costs have been reduced by about 15% since the introduction of CFX. Even during the peak season, they were able to get through without overtime and without turning down a single job. In addition, the defect rate was improved, and the introduction of additional equipment was considered only three months after the introduction.

Want to improve their cutting skills and efficiency.

After the introduction of CFX, the amount of work that can be cut in a day has greatly increased, and the total amount of work that can be ordered has increased, so sales and profits have increased. In addition, overtime hours have decreased, and employee satisfaction is high. Seeking further efficiency, table expansion was decided in five months after the introduction of the main body.